唐县铜雕生产厂家

铜雕塑的标准制作工艺流程。

The standard production process of copper sculpture.

第一步：制作小泥塑 （每件产品的前身都需要一个泥塑原型，泥塑都是经过雕塑师在原创设计稿的基础上反复揣摩、推敲之后进行的再创作，泥塑的造型好坏、神韵的体现与否、意图的表达呈现直接影响今后的产品好坏，所以优秀的泥塑离不开优秀的雕塑师）

The first step: the production of small clay (each product's predecessor needs a clay prototype, clay are sculptors in the original design on the basis of pondering and deliberation of after the re creation, the other is the charm of clay, and reflect the intention of the expression show a direct impact on the future of the quality of the product. So good clay cannot do without excellent sculpture division)

第二步：上大泥覆盖雕塑造型。上泥完毕一边用木槌砸实一边补平泥间空袭。全部上泥后对大造型进行不断的调整。造型不准需要返工对骨架进行休整直到满意，以上必须由专业雕塑师（湖北省环艺强大的设计团队）来完成。从此阶段开始雕塑必须经常喷水保持不开裂，半途公休要覆盖塑料薄膜进行保湿直到雕塑模完成后。

Second step: large mud covered with sculpture. The mud after side with a mallet to hit real while filling mud between air strikes. After all the mud, the big shape is constantly adjusted. No other need to rework rest until satisfaction of skeleton, above must be done by a professional sculptor (design team in Hubei Province, strong) to complete. From the beginning of sculpture must often keep water without cracking, halfway to public sculpture until the moisture after the plastic film covering model.

第三步：制作泥雕原型 （再次制作出来的矽胶模具已经很完整及完好了，加热熔化的石蜡被加压射入矽胶模具来制造出一个腊胚，此腊胚乃为将生产产品的真实外形复制品。）

The third step: making clay prototype (silica gel mold again produced is complete and intact, heating melted paraffin is pressed into the silicone mold to produce a wax embryo, this is the true shape of wax embryo will produce copies.)

第四步：雕塑大型完成，通知甲方对大造型进行审核和提出意见或修改。继续不断的推敲调整和细节塑造达到完美，全部完成造型后进行整体推光泥塑，使用刮片进行推光，泥雕原型需要再对照流程三的原型胚体作修整，这是很重要的一环，因此环节会直接影响到产品最后的造型及表面效果。

The fourth step: the sculpture is completed in a large scale. Party A will inform Party A to review the big shape and make suggestions or modifications. Continue to adjust and perfect shape scrutiny details, completed after the other whole push light clay, use of scraping mud carved push light, need to control the prototype prototype of embryo three as the dressing process, this is very important, so the link will directly affect the final product shape and surface effect.